Monitor Unit - Furuno FAR-2107 Series Service Manual

7.5 Monitor Unit

7.5.1 Overview
See page.4-41 for the selecting and setting of a monitor unit to be connected.
See page.7-76 for connection with a monitor unit not given below.
- MU-201CR
This is an LCD of SGXA type. SXTA signals are inputted from RPU-013 by the
setting of S1-1/2 (OFF/OFF) of the SPU board.
- MU-231CR
This is an LCD of UXGA type. SXGA signals having a little larger width are
inputted from RPU-013 by the setting of S1-1/2 (ON/OFF) of the SPU board.
However, since these signals do not fit the LCD size, they are converted on the
DVI I/F board of MU-231CR so as to fit the LCD size.
Output signal
from RPU-013
Monitor display
process dots
Dots in radar
effective radius
Radar effective
radius
SPU board
S1-#1/2
MU-201CR
(20. inches)
1024 x 1280 dots
1024 x 1280 dots
496 dots
308 mm
OFF/OFF
Table 7.5.1 LCD monitor unit
MU-231CR
(23.1 inches)
1024 x 1360 dots
1200 x 1600 dots
496 dots
340 mm
ON/OFF
7-73
7.5 Monitor Unit
Remarks
The number of output dots
differs according to the
setting of S1 of the SPU
board.