Furuno FAR-2107 Series Service Manual page 189

1 BACK
2 CHART COLOR
3 OWN TRACK INTERVAL
4 OWN TRACK COLOR
5 TRG TRACK INTERVAL
6 TRG TRACK COLOR
5 PLOTTER
7 CURSOL L/L ALIGN
8 [DATA ERASE]
9 [DISPLAY]
[CARD1/2]
1 BACK
2 DRIVE SELECT
3 [READ CARD]
4 [WR MARK]
6 CARD
5 [WR NAV LINE WPT]
6 [WR OWN TRACK]
7 [WR TARGET TRACK]
8 [WR SETTING DATA]
9 [WR INSTALLATION DATA]
0 NEXT)
Cont'd
Specifies the chart color
A chart is drawn in PLOTER and RADAR + PLOTER.
Sets the track interval and track color of the own ship and
other ship.
Sets whether to add the offset value after chart offset to the
L/L value of the cursor (+) or not. Offset the L/L position
on the radar map and radar screen.
During the offset, "ALIGN" is displayed if the cursor icon
is set to L/L. For offset, execute CHART ALIGN in the
[Cursor] menu.
Erases the own track, target track, mark, WPT and NAV
line.
Turns on and off the L/L line, past position, mark land
density, place name and buoy displayed on the plotter
screen.
Selects the RAM card slot of CU-200.
"A" is for the left slot and "B" for the right slot. When the
2nd CU-200 is added, the drives "C" and "D" are added.
Reads data from the RAM card. During reading the data, a
message "WORKING IN PROGRESS" is displayed in
Alert box in the lower right screen.
Each selected data is written on the RAM card.
Mxxxxxxx: WR MARK
Wxxxxxxx: WR NAV LINE WPT
Txxxxxxx: WR OWN TRACK
Axxxxxxx: WR TARGET TRACK
Sxxxxxxx: WR SETTING DATA
Ixxxxxxx: WR INSTALLATION DATA
Note:
Writing operation can be checked by the message "WR
CARD DATA" in the Alert box in the lower right screen.
3-24
3.3 Main Menu Tree