Setting List - Furuno FAR-2107 Series Service Manual

4.7.1 Setting List

In the factory setting, all the DIP switches are set to OFF and jumpers are set to #1 except that JP1 is set
to #1, #2 and #3.
Segment Setting contents
SW 1
SW1-#1, #2, #3
SW1-#4, #5, #6
SW1-#7, #8
SW 2
SW2-#1
SW2-#2, #3
SW2-#4
SW2-#5, #6 NMEA output interval
(See Table 4.7.4)
setting and output
sentence/Baud rate.
Detection of "Stator"
SW2-#7
SW2-#8
SW1-#1 #2
OFF OFF OFF 360 x
Ratio
ON
OFF ON
ON
SW1-#4 #5
OFF OFF OFF AC synchrous
OFF OFF OFF DC synchrous
Gyro type
ON
OFF ON
ON
SW1-#7 #8
OFF OFF
Frequency ON
OFF ON
ON
SW2-#1
ON
Rotor voltage OFF
ON
OFF
SW2-#2 #3
ON
OFF OFF
Stator voltage ON
OFF OFF
ON
OFF OFF
SW2-#4
Self test ON: Self-test "YES"
OFF:Self- test "NO"
SW2-#5
*The baud rate is determined according to the setting of
-OFF: Enable (When detected, AD outputs stop on 25 ms
disconnection
- ON: Disable
CPU reset Reset by switching ON -> OFF.
Table 4.7.3(1/2) Setting List
Setting conditions
#3
OFF OFF 180 x
OFF 90 x
ON OFF 36 x
#6
OFF OFF DC step system
OFF Full-wave pulsating current
ON OFF Half-wave pulsating current
50/60 Hz
OFF 400 Hz
500 Hz
ON DC
20 VAC to 45 VAC
30 VAC to 70 VAC
40 VAC to 90 VAC
60 VAC to 135 VAC
OFF 20 VAC to 45 VAC
30 VAC to 70 VAC
OFF 40 VAC to 90 VAC
60 VAC to 135 VAC
OFF 20 VDC to 60 VDC
40 VDC to 100 VDC
#6 Interval
OFF OFF 1 s
ON OFF 200 ms
OFF ON 100 ms
ON ON 25 ms
SW3-#2.
interval only.)
4-44
4.7 Setting of AD-100 or GC-10
Sentence
HDT＋VHW
HDT
HDT
HDT