Furuno FAR-2107 Series Service Manual page 32

4. Remove the RFC board and its case from the RF unit.
5. Attach new RFC board case and then RFC board on it with seven spacer
screws. Lead the cables through the edge saddle or square bushes.
6. Fix the RFC board cover on the RFC board with the original fixing screws.
2. Connecting the ground wire
Remove the rear cover of the RF unit and connect the ground wire between a
fixing screw for the magnetron and a fixing screw for the MD board. Use original
screws to fix the wire.
Ground wire
RFC board
MD board
Fix the wire by original
screw.
RFC board cover
Fixing RFC board cover
2
Fix the wire by original
screw.
Ground wire