Network Transmission Setting Between; How To Set The Forwarding Distance - Furuno FAR-3220-NXT Installation Manual

[6 ROUTE SOURCE]
Set the IP address when receiving route information from a route source other than
FMD-3200/3300.
[7 WIND REF TEXT]
Select the format of the wind information on the [NAV data] box. For the wind refer-
ence, set on the [WIND STB] (Main menu [4 INFORMATION BOX] [2 SET NAV
DATA] [6 WIND STB]) menu.
[8 FERRY MODE]
Select the direction in which the antenna was in-
stalled (oriented) at [ANTENNA DIRECTION].
3.7 Network Transmission Setting Between ECDIS
and Radar
Connect the ECDIS and FAR-3xx0 series radar with the LAN cable to show the radar
echo and TT symbols on the ECDIS chart display, and show the ECDIS route and user
chart symbols on the radar display.
1. Press the MENU key five times while holding down the [1 HL OFF] key.
2. Select [9 RADAR INSTALLATION] [4 TT PRESET] [1 TTM/TTD PREFER-
ENCE] and then select [TRUE].
3. On the ECDIS, open the [Common Installation Setting] menu.
4. Open the [Own Ship Setting] menu on the ECDIS to select [Radar Antenna] on
the menu bar.
5. For one antenna unit, check [RAS001]. For two antenna units, check[ RAS001]
and [RAS002].
3.8

How to Set the Forwarding Distance

Set the forwarding distance* as follows. The configuration can be copied to other units
connected to the network after saving the configuration.
*: The distance the ship travels straight after the steering control.
1. In the chart mode, press Ctrl,
Shift and t keys simultane-
ously on the control unit or
keyboard. A dialog box for
password input appears.
3. SETTINGS AND ADJUSTMENTS
3-13