Adjustment of the top link
1 - Top link
2 - Lock nut
Lengthening or shortening the top link will change the
angle of the implement.
The locating hole of the top link varies with the type of
implement used.
The most common locations are the 1st and 2nd hole from
the top.
1 - Position of Top Link
1) For general implement: Use the Pin to Position 3 point.
2) For Draft control: Use the Pin to Position 2 point.
Adjustment of lower link
1 - Lift Rod
The adjustment is done with the adjusting handle on the
Right hand Lift rod.
To shorten it wind the handle clockwise and to lengthen it
wind it counterclockwise.
When adjusted correctly hold the turn buckle with the
stopper provided.
Lower (if equipped extendable type)
Push the point area and pull the end of the lower link to adjust the length of lower link.
Danger: Only use drawbar to tow and keep the 3 point linkage in raised position when toeing
with the drawbar. Position can create unbalance causing the Tractor to roll-over & Result the death
or serious injury.
CONTROLS, INSTRUMENTS & OPERATIONS
57
U18N043
U18N044
U18N045