Operating The Hydraulics; Position Control; Draft Control Lever - Zetor UTILIX HT 45 Operator's Manual

Operating the hydraulics

The hydraulics are powered with an engine driven hydraulic pump and controlled with a position control lever
mounted beside the driver.
Caution: When working with the 3-point linkage, keep well clear of the operating radius of the
lift arms and any attached implement. This is to avoid the risk of injury in the case of incorrect
maneuvers.

Position control

1 - Position control Lever
Implements can be raised and lowered with the hydraulic
position control lever and can be stopped at any position
by stopping the lever.
To ensure a consistent working depth the adjustable stop
can be set to ensure that the implement returns to the
same depth every time.
To raise the implement: Pull the lever back
To lower the implement: Push the lever forward.
Warning: After finishing the work, always lower the implement to the ground and switch off the
engine, set the parking brake to avoid injuries and accidents.

Draft control lever

1 - Draft control Lever
2 - Free Floating
3 - Scope of Draft control
4 - Ascent
Soil engaging implements can be set for precision work by
using draft control. By mounting the lever forward, the
depth increase. By moving the lever backward, the depth
decreases.
CONTROLS, INSTRUMENTS & OPERATIONS
52
U18N033
U18N034