THE PTO MONITOR LAMP on the dash panel indicates the state of the PTO shaft.
1. If the monitor glows: The PTO is rotating.
2. If the monitor is off: The PTO is off.
3. If the monitor blinks: The PTO is currently stopped.
If the driver is standing on the seat or out of the driver's seat when the PTO is in operation, the PTO lamp
flashes with a beep and stops operating.
Two switches operate the independent PTO.
1. PTO ON/OFF SWITCH: PTO ON/OFF switch is located on the LHS. On the steering column and can be
identified easily with its built in red colored indicator.
When the switch is pushed down to start the PTO indicator glows to indicate that the switch and the PTO are
in ON position, if the switch is pushed down again the indicator goes off signaling that the PTO is OFF.
2. PTO CONTROL SWITCH: This switch is located near the starting key location on the dash panel. There
are three positions marked for this switch.
OFF at the center
MANUAL at the left
AUTO AT THE RIGHT.
1 - PTO On-Off S/W
2 - PTO Mode S/W
CONTROLS, INSTRUMENTS & OPERATIONS
43
U18N019