Turn Buckle Stabilizers Adjustment (Check Link); Adjustment Of The Top Link; Adjustment Of The Lift Rod (Left, Right) - Zetor HORTUS HS CL Operator's Manual

Turn Buckle Stabilizers Adjustment (Check Link)

The stabilizers are intended for limiting or preventing
implement side movement.
The length of stabilizers is adjusted by removing the pin
and rotating the turn buckle barrel by which the threaded
ends are interconnected.
1 - Turn buckle
2 - Pin

Adjustment of The Top Link

Lengthening or shortening the top link will change the angle of the implement.
The locating hole of the top link varies with the type of implement used.
The most common locations are the 1st and 2nd hole from the top.
For general implement: Use the Pin to ''A'': point
For Draft control: Use the Pin to ''B'' point
1 - Top Link Adjustable Handle
2 - Lock Nut
3 - Position of Top Link
4 - A
5 - B

Adjustment of The Lift Rod (Left, Right)

Adjust the length of the lift rod by screwing the adjustable.
Handle in or out. Adjust the length of the lift rod as
necessary to set the implement in its working position
parallel to the ground.
1 - Lift Rod
DESCRIPTION OF TRACTOR CONTROLS
64
HODP078
HODP079
HODP080