Adjustment Of The Top Link; Adjustment Of The Lift Rod (Left, Right); Adjustment Of Lower Link; Lower (If Equipped Extendable Type) - Zetor UTILIX CL Operator's Manual

Adjustment of the top link

1 - Top link adjustable handle
2 - Lock nut
3 - Position of top link
4 - A
5 - B
Lengthening or shortening the top link will change the angle of the implement.
The locating hole of the top link varies with the type of implement used.
The most common locations are the 1st and 2nd hole from the top.
For general implement: Use the Pin to ''A'': point
For Draft control: Use the Pin to ''B'' point

Adjustment of the lift rod (left, right)

1 - Lift Rod
Adjust the length of the lift rod by screwing the adjustable.
Handle in or out. Adjust the length of the lift rod as
necessary to set the implement in its working position
parallel to the ground.

Adjustment of lower link

1 - Lift Rod
The adjustment is done with the adjusting handle on the
Right hand Lift rod.
To shorten it wind the handle clockwise and to lengthen it
wind it counterclockwise.
When adjusted correctly hold the turn buckle with the
stopper provided.

Lower (if equipped extendable type)

Push the point area and pull the end of the lower link to adjust the length of lower link.
Danger: Only use drawbar to tow and keep the 3 point linkage in raised position when toeing
with the drawbar. Position can create unbalance causing the tractor to roll-over & result the death or
serious injury.
CONTROLS, INSTRUMENTS & OPERATIONS
60
UCL18N038
UCL18N039
UCL18N040