Table of Contents
Advertisement
Check and service
This section gives full details of the service procedures necessary to maintain your Tractor at peak efficiency
while the lubrication and maintenance chart provides a ready reference to these requirements.
Service inspections
Service inspections are performed as follows:
The first service inspection at the state of the engine hour counter of 50 EH maximum, but not later than
6 months after commissioning of the tractor. The second service inspection after covering another 200 EH
(at the state of the engine hour counter of 250 EH maximum) but not later than 12 months after the first
service inspection. Next service inspections always after covering another 250 EH but not later than 12
months after the previous service inspection. The service inspections are a part of tractor maintenance. The
services authorized by Zetor will provide professional performance of service inspections according to the
manufacturer's instructions.
Pre-start checks
To avoid problems it is recommended that a range of checks be carried out daily before starting the tractor.
For full details of the items and frequency please refer to the following tables - Periodical check and service
tables.
Engine coolant
1 - Drain Cock
Remove the radiator cap and ensure that the coolant is up
to the filler neck and that it is clean with the correct anti-
freeze or anti corrosion inhibitor in it.
If the coolant is a rusty color, drain the system completely
and refill with the correct mixture of water and anti-freeze
or corrosion inhibitor.
1 - Radiator Cap
2 - Reservoir Tank
LUBRICATION & MAINTENANCE
69
U18N056
U18N057
Advertisement
Table of Contents
