CONTROLS, INSTRUMENTS & OPERATIONS
Operating the 3 point linkage (TPL)
U18N041
1 - Top Link
2 - Link Bracket
3 - Check Link
4 - Extendable Type
5 - Swing Draw Bar
6 - Lower Link
7 - Adjusting Handle
8 - Lift Rod
Check chain (telescopic stabilizers) adjustment
The stabilizers are intended for limiting or preventing
implement side movement.
There should be no clearance (Position 1) during
implement transport and when working with grades, rollers
mowers, seeders, drills and similar implements.
However, a slight play is necessary (Position 2) when
working with ploughs, harrows, ditchers, cultivators and
the like: That is when working with ''draft control''.
The length of stabilizers is adjusted by removing the pin
and rotating the turn buckle barrel by which the threaded
ends are interconnected.
U18N042
56