Zetor UTILIX HT 45 Operator's Manual page 43

CONTROLS, INSTRUMENTS & OPERATIONS
Warning lights
U18N017
High beam lamp is operated on the combination switch.
Low beam lamp is operated on the combination switch.
Parking brake lamp is operated on when the ignition key is turned onto ''ON'' with the hand brake
engaged. These lamp will blink. If you do not operate the parking brake if the seat away from the
lamp blinks with buzzer sound.
PTO monitor Lamp This comes on while the PTO shaft is rotating.
Fuel Level indicator lamp. If it comes on while the engine is running, fill the tank with fuel.
Engine oil pressure lamp will go out as soon as the engine starts if the oil pressure is correct. If it
comes on while the engine is running, stop the engine and get expert advice.
Charge lamp
This light will go off as soon as the engine starts to run to indicate that the alternator is changing.
(Please note, as broken fan belt can cause the light to come on, please stop the engine as
overheating can occur if not rectified immediately)
Glow signal Lamp is operated on when the ignition key is turned onto ''GLOW'' or ''ON'' for
preheating.
Cruise Control Lamp
Will turn on when cruise control is engaged.
Forward indicator lamp is operated when F/R Lever indicated forward, Reverse indicator lamp
is operated when F/R Lever indicated reverse.
Check Lamp
Will turn on when the key switch is set to ON position and safety start conditions are not satisfied.
Safety start conditions: 1 Brake pedal is depressed 2 PTO ON/OFF switch is OFF.
If it comes on when safety start conditions are satisfied, some electric part is in trouble.
42