Attachment Of Intermediate Tube For Image Projection - Zeiss Axioskop 2 plus Operating Manual

Axioskop 2 plus
Axioskop 2 mot plus
2.2.18 Attachment of intermediate tube
for image projection
The intermediate tube for image projection can
only be used with the binocular tube from the
Axioplan 2 line.
• Use SW 3 ball-headed screwdriver to loosen
clamping screw (2-48/8) and remove available
tube of the Axioskop 2 plus in an upward
direction.
• Insert
dovetail of
Axioskop 2 plus (2-48/6) in the stand opening
(2-48/9) on the underside and slightly tighten
clamping screw (2-48/8).
• Insert fixation screw (2-48/5) in countersunk
hole of the adapter (2-48/6) and screw it into
the drilled hole (2-48/7) on the stand.
• Tighten clamping screw (2-48/8) and fixation
screw (2-48/5).
• Attach intermediate tube for image projection
(2-48/2) on the stand and tighten clamping
screw (2-48/10) only slightly at first. Centering
is performed using the dovetail.
• Insert second clamping screw with washer
(2-48/3) in the drilled hole provided on the rear
of the intermediate tube at (2-48/4), screw it in
the rear threaded hole of the adapter and
tighten it slightly.
• Align the intermediate tube with the edges of
the upper stand part and alternately tighten
clamping screws (2-48/3) and (2-48/10).
• Use the cover of the tube lens storage case to unscrew the tube lens from the Axioplan 2 tube
(2-48/1) and store it in the case.
• Attach Axioplan 2 tube (2-48/1) without tube lens on the intermediate tube, align it with the edges of
the intermediate tube and tighten clamping screw (2-48/11).
• Equip the Axioplan 2 tube (2-48/1) with eyepieces with field number 23.
☞
The zoom system always points to the right. The specimen is positioned on this side below the
exit opening of the zoom tube.
B 40-075 e 10/03
START-UP
Attachments and conversions
the adapter for the
Fig. 2-48 Attachment of intermediate tube
for image projection
Carl Zeiss
2-35