Attaching The Intermediate Tube For Image Projection - Zeiss Axioskop 40 Operating Manual

Carl Zeiss
Fig. 2-49 Attaching intermediate tube for
image projection
• Align the intermediate tube with the edges of the upper stand and alternately tighten clamping
screws (2-49/3) and (2-49/10).
• Use the cover of the tube lens storage case to unscrew the tube lens from the Axioplan 2 tube
(2-49/1) and store it in the case.
• Attach Axioplan 2 tube (2-49/1) without tube lens to the intermediate tube, align it with the edges of
the intermediate tube and tighten with clamping screw (2-49/11).
• Equip the Axioplan 2 tube (2-49/1) with eyepieces with field number 23.
The zoom system invariably points to the right. The specimen is positioned on this side below
the input opening of the zoom tube.
2-44
START-UP
Attachments and conversions
2.2.17
The intermediate tube for image projection can
only be used with the binocular tube from the
Axioplan 2 range.
• Use an SW 3 ball-headed screwdriver to undo
clamping screw (2-49/8) and remove the tube
on the Axioskop 40 / 40 FL upwards.
• Insert the Axioskop connector plate (2-49/6)
with the dovetail on the bottom into the stand
opening (2-49/9) and slightly tighten clamping
screw (2-49/8).
• Insert
countersunk hole of the connector plate
(2-49/6) and screw it into the drilled hole
(2-49/7) on the stand.
• Tighten clamping screw (2-49/8) and fastening
screw (2-49/5).
• Attach the intermediate tube for image
projection (2-49/2) to the stand and tighten
clamping screw (2-49/10) only slightly at first.
The dovetail is used to help centering.
• Insert the second clamping screw with washer
(2-49/3) into the drilled hole provided at the
back of the intermediate tube at (2-49/4),
screw it into the rear threaded hole of the
connector plate and tighten it slightly.
Attaching the intermediate tube
for image projection
fastening screw 2-49/5)
B 40-810 e 12/01
Axioskop 40
Axioskop 40 FL
into the