Attachment Of Intermediate Tube With Height Adjustment - Zeiss Axioskop 2 plus Operating Manual

Carl Zeiss
Fig. 2-40 Attachment of intermediate tube
with height adjustment
• Remove upper dust cap (2-40/4) from the intermediate tube with height adjustment.
• Insert the binocular ergotube with the dovetail in the upper opening (2-40/10) of the intermediate
tube, align it and fix it with the clamping screw (2-40/6).
2-26
START-UP
Attachments and conversions
2.2.11
The intermediate tube with height adjustment may
only be used in combination with a binocular
ergotube.
When removing the intermediate tube and
attaching the binocular ergotube, make absolutely
sure to screw the tube lens into the binocular
ergotube again. Otherwise, correct imaging of the
specimen is not possible.
• Use SW 3 ball-headed screwdriver to loosen
clamping screw (2-40/7) and remove attached
binocular tube in an upward direction.
• Remove dust cap (2-40/9) from the dovetail of
the intermediate tube with height adjustment
(2-40/5).
• Insert dovetail of intermediate tube in the stand
opening (2-40/8) and tighten clamping screw
(2-40/7) only slightly.
• Align intermediate tube with the outer edges of
the
(2-40/7).
• Unscrew tube lens (2-40/2) from the binocular
ergotube (2-40/1). The tool from the storage
case (2-40/3) must be used to remove the tube
lens. Insert pins in the drilled holes of the tube
lens mount and remove tube lens by turning.
The tube lens should then be stored in the case.
Attachment of intermediate tube
with height adjustment
stand, then tighten
Axioskop 2 plus
Axioskop 2 mot plus
clamping screw
B 40-075 e 10/03