Attachment Of Intermediate Tube For Image Projection - Zeiss Axioskop 2 Manual

10
Fig. 2-47 Attachment of intermediate tube
for image projection
• Use the cover of the tube lens storage case to unscrew the tube lens from the Axioplan 2 tube
(2-47/1) and store it in the case.
• Attach Axioplan 2 tube (2-47/1) without tube lens on the intermediate tube, align it with the edges of
the intermediate tube and tighten clamping screw (2-47/11).
• Equip the Axioplan 2 tube (2-47/1) with eyepieces with field number 23.
The zoom system always points to the right. The specimen is positioned on this side below the
exit opening of the zoom tube.
2-34
START-UP
Attachments and conversions
2.2.17
The intermediate tube for image projection can
only be used with the binocular tube from the
Axioplan 2 line.
• Use SW 3 ball-headed screwdriver to loosen
clamping screw (2-47/8) and remove available
tube of the Axioskop 2 in an upward direction.
• Insert dovetail of the adapter for the Axioskop 2
(2-47/6) in the stand opening (2-47/9) on the
underside and slightly tighten clamping screw
(2-47/8).
• Insert fixation screw (2-47/5) in countersunk
hole of the adapter (2-47/6) and screw it into
the drilled hole (2-47/7) on the stand.
• Tighten clamping screw (2-47/8) and fixation
screw (2-47/5).
• Attach intermediate tube for image projection
(2-47/2) on the stand and tighten clamping
screw (2-47/10) only slightly at first. Centering
is performed using the dovetail.
• Insert second clamping screw with washer
(2-47/3) in the drilled hole provided on the rear
of the intermediate tube at (2-47/4), screw it in
the rear threaded hole of the adapter and
tighten it slightly.
• Align the intermediate tube with the edges of
the upper stand part and alternately tighten
clamping screws (2-47/3) and (2-47/10).
Axioskop 2 / Axioskop 2
Attachment of intermediate tube
for image projection
B 40-075 e
MOT
06/98