Setting Up A Wireless (Wifi) Network Connection - Pitney Bowes SendPro C Operator's Manual

Connectivity information
5. If it fails to connect, remove the network cable from the back of the meter.
6. Tap the Connect button. Wait for the attempted connection to fail.
7. Plug the network cable back in.
8. Delete the values in the IP Address, Netmask, Gateway, and DNS Address fields.
9. Enter the IP Address, Netmask, Gateway, and DNS Address that you recorded in step 2.
10. Tap Connect.
NOTE: your device will remember the Static IP information even if you switch back to DHPC and
then back again. This information includes IP Address, Netmask, Gateway and DNS Address as
well as the proxy information.
If you use a proxy server, refer to Related topics.
Related topics:
Finding the Product Code Number (PCN) and serial number
l
Setting up a proxy server
l
Checking your network connection
l

Setting up a wireless (WiFi) network connection

For information about the connection settings required on your network, contact your IT department.
Refer to the SendPro C connectivity guide for additional information.
1. Tap the Settings (gear) icon in the global toolbar.
2. Tap Wi-Fi in the Device & Network section.
3. Choose your WiFi network from the list. If your WiFi network is hidden, tap Add Network to add it.
4. Enter your WiFi password and identity.
Tip: Use the show password option to make sure that your password is entered correctly.
Pitney Bowes Operator Guide August 2019 44