Danfoss VLT Automation Drive FC 300 Instruction Manual page 37

VLT ® Automation Drive FC 300
Instruction Manual High Power
Figure 3.24: Lifting method for mounting drive on wall
3.3.8 Connector/Conduit Entry - IP21 (NEMA 1) and IP54 (NEMA12)
Cables are connected through the connector plate from the bottom. Remove the plate and plan where to place the entry for the connectors or conduits.
Prepare holes in the marked area on the drawing.
The connector plate must be fitted to the adjustable frequency drive to ensure the specified degree of protection, as well as ensuring proper cooling of
the unit. If the connector plate is not mounted, it may trip the unit.
Enclosure D1 + D2
Enclosure E1
Cable entries viewed from the bottom of the adjustable frequency drive - 1) Line power side 2) Motor side
MG.33.U2.22 - VLT ® is a registered Danfoss trademark
3 How to Install
3
3-25