Safe Stop - Danfoss VLT Automation Drive FC 300 Instruction Manual

2 Safety Instructions and General Warning

2.1.6 Safe Stop

The FC 302 can perform the safety function
It is designed and deemed suitable for the requirements of Safety Category 3 in EN 954-1. This function is called safe stop. Prior to integrating and using
2
safe stop in an installation, a thorough risk analysis must be carried out on the installation in order to determine whether the safe stop functionality and
safety category are appropriate and sufficient. In order to install and use the Safe Stop function in accordance with the requirements of Safety Category
3 in EN 954-1, the related information and instructions of the FC 300 Design Guide MG.33.BX.YY must be followed! The information and instructions
contained in the Instruction Manual are not sufficient for a correct and safe use of the safe stop functionality!
2-4
Safe Torque Off (As defined by draft CD IEC 61800-5-2) or
MG.33.U2.22 - VLT ® is a registered Danfoss trademark
VLT ® Automation Drive FC 300
Instruction Manual High Power
Stop Category 0 (as defined in EN 60204-1).