Cisco vEdge Series Hardware Installation Manual page 38

Front and Rear Panel Components
Table 9:
LED
Power
Status (SYS)
RJ-45 Ethernet Port
LEDs (0–4)
RJ-45 Ethernet Port
LEDs (0–4)
Reset Button
The Reset button on the front panel is recessed, to avoid accidentally pressing it while the router is operational.
To press the Reset button, use a sharp narrow tool. Table 2 describes the effects of pressing the Reset button.
Table 10:
Press
Duration
Short press
Long press
Rear Panel
The rear panel of the vEdge 100b router has a small metal-enforced hole for attaching a Kensington lock to
secure the router. See Chassis Views for the location of these components.
Hardware Installation Guide for vEdge Routers
32
Color Status
Green/Red
Green/Yellow/Red
Green
Yellow
Behavior
Pressing for two seconds resets and reboots the router.
Pressing for 10 seconds resets the router and reboots it with factory default configuration.
• Off: System is not on
• Green: System is powered on
• Red: Power supply fault
• Off: System is not on
• Solid Green: System is fully functional and OMP connection
is in the Up state
• Blinking Green: System is booting up
• Solid Yellow: System is up but OMP connection is in the
Down state
• Solid Red: System has detected a major system level
fault—one of the necessary daemons in the system is
down (system will usually reboot shortly after this)
• Off: No link and corresponding yellow LED is off
• Solid Green: 1000 Mbps link detected
• Blinking Green: 1000 Mbps link detected and link activity
• Off: No link and corresponding green LED is off
• Solid Yellow: 10/100 Mbps link detected
• Blinking Yellow: 10/100 Mbps link detected and link activity
vEdge 100b Router