Cisco vEdge Series Hardware Installation Manual page 238

Ports and Connectors
Table 5 describes the LEDs on the management port.
Table 83:
LED
Activity
Link
Console Port
The console port on a vEdge 5000 router is accessible via the following external interface:
• An RS-232 serial interface that uses an RJ-45 connector to connect to a console management device.
See Figure 5.
Figure 5: RJ-45 Connector
The default baud rate for the console port is 115,200 baud.
Table 6 provides the pinout information for the RJ-45 console port connector.
Table 84:
P i n Signal
1 RTS Output
2 NC
3 TxD Output
4 Signal
Ground
Hardware Installation Guide for vEdge Routers
232
Color State and Description
Amber • Blinking—There is link activity.
• Off—There is no link activity.
Amber Link is up at the rate of 1,000 Mbps.
Green Link is up at the rate of 100 Mbps.
Off Link is down or is up at the rate of 10 Mbps.
Description
Request to
send
No connect
Transmit data
Signal ground
vEdge 5000 Router