Cisco vEdge Series Hardware Installation Manual page 170

Front Panel Components
Table 51:
LED Color
SYS Green/Amber/Red
STAT Green
PWR Green/Red
0
PWR Green/Red
1
Reset Button
The front panel of the vEdge 2000 router has a reset button. The reset button is recessed to avoid accidentally
pressing it while the router is operational. To press the reset button, use a sharp narrow tool. Table 2 describes
the effects of pressing the reset button.
Table 52:
Press
Duration
Short press
Long press
SD Card Slot
The front panel of the vEdge 2000 router has an SD card slot. The SD card slot has the following specifications:
• High speed bus: maximum 25 MB/second
• Supported card types: SD, SDHC
Hardware Installation Guide for vEdge Routers
164
Description
• Off: System is not on
• Green: System is healthy and operating fine
• Blinking Green: System is booting up
• Red: Major failure or alarm is present
• Off: Status of OMP to vSmart controller is down
• Green: Status of OMP to vSmart controller is up
• Off: Power supply unit 0 is not present (or router is not
powered)
• Green: 12-Volt output is OK on power supply unit 0
• Red: Fault on power supply unit 0
• Off: Power supply unit 1 is not present (or router is not
powered)
• Green: 12-Volt output is OK on power supply unit 1
• Red: Fault on power supply unit 1
Behavior
Pressing for two seconds resets and reboots the router.
Pressing for 10 seconds resets the router and reboots it with factory default configuration.
vEdge 2000 Router