Power Supply And Cooling In Cisco Vedge 2000 Routers - Cisco vEdge Series Hardware Installation Manual

vEdge 2000 Router
FRU
2-Port 10-Gigabit Ethernet SFP+ PIM
Gigabit Ethernet transceivers
10-Gigabit Ethernet transceivers
Fan tray

Power Supply and Cooling in Cisco vEdge 2000 Routers

The vEdge 2000 router ships with two AC power supplies installed. Read this article to learn more about the
AC power supply in the router as well as about the cooling system and airflow through the router chassis.
AC Power Supply in vEdge 2000 Router
The vEdge 2000 router ships with two AC power supplies installed. The second power supply is for redundancy
and load-balancing. If one of the AC power supplies fails due to device failure or input power line failure, a
single unit is sufficient to power the entire router.
The AC power supply in a vEdge 2000 router is a hot-insertable and hot-removable field replacement unit
(FRU). You can remove and replace the power supply in the rear of the chassis without powering off the
router or disrupting normal functioning.
Table 1 describes the AC power supply specifications for the vEdge 2000 router.
Table 67:
Item
AC input voltage
AC input line frequency
Maximum output power
Nominal power
consumption
FRU Model Number
• PIM-2x10GE-SFP+
• SFP-1GE-SX
• SFP-1GE-LX
• SFP-1GE-EX
• SFP-1GE-Base-T
• SFP+-10GE-SR
• SFP+-10GE-LR
• vEdge-2000-Fan
Specification
90-264
Vrms
47-63 Hz
800 W
125 Watts
Hardware Installation Guide for vEdge Routers
Power Supply and Cooling in Cisco vEdge 2000 Routers
181