Supported Transceivers - Cisco vEdge Series Hardware Installation Manual

vEdge 1000 Router
Reset Button
The front panel of the vEdge router has a Reset button. The Reset button is recessed to avoid accidentally
pressing it while the router is operational. To press the Reset button, use a sharp narrow tool. Table 2 describes
the effects of pressing the Reset button.
Table 34:
Press
Duration
Short press
Long press
SD Card Slot
The front panel of the vEdge 1000 router has an SD card slot. The SD card slot has the following specifications:
• Normal speed bus: maximum 10 MB/second
• Supported card types: SD, SDHC

Supported Transceivers

This article provides a list of copper and fiber transceivers that have been tested and qualified for use in vEdge
1000 and vEdge 2000 routers. You can order the transceivers that have a Viptela part number in the tables
below directly from Viptela.
Table 35:
Manufacturer & Part
Number
Finisar FCLF-8521-3
Finisar
FCLF8521P2BTL
Cisco-Avago
SFBR-5766PZ-CS2
Behavior
Pressing for two seconds resets and reboots the router.
Pressing for 10 seconds resets the router and reboots it with factory default configuration.
Viptela Part vEdge
Number 1000
Router
SFP-1GE-Base-T X
SFP-1GE-Base-T X
X
vEdge vEdge Description
2000 5000
Router Router
X X • Small form-factor pluggable
(SFP) transceiver
• RJ45-type connector
• 10/100/1000-Mbps Ethernet
X X • SFP transceiver
• RJ45-type connector
• 10/100/1000-Mbps Ethernet
X X • SFP transceiver
• RJ45-type connector
• 10/100/1000-Mbps Ethernet
Hardware Installation Guide for vEdge Routers
Supported Transceivers
117