Cisco vEdge Series Hardware Installation Manual page 183

vEdge 2000 Router
Management Port
The management port on a vEdge 2000 router uses an RJ-45 connector to connect to a management device
for out-of-band management.
The management port uses an autosensing RJ-45 connector to support a 10/100/1000Base-T connection. The
two LEDs on the port indicate link/activity on the port and the administrative status of the port. See Management
Port LEDs below.
Table 4 provides the pinout information for the RJ-45 connector for the management port.
Table 62:
P i n Signal
1 TRP1+
2 TRP1-
3 TRP2+
4 TRP3+
5 TRP3-
6 TRP2-
7 TRP4+
8 TRP4-
Management Port LEDs
The management port on the vEdge 2000 router has two LEDs that indicate link/activity and port status. See
Figure 4.
Figure 4: LEDs on the Management Port on a vEdge 2000 Router
Description
Transmit/receive data pair
1
Transmit/receive data pair
1
Transmit/receive data pair
2
Transmit/receive data pair
3
Transmit/receive data pair
3
Transmit/receive data pair
2
Transmit/receive data pair
4
Transmit/receive data pair
4
Hardware Installation Guide for vEdge Routers
Ports and Connectors
177