Accessing Redboot Commands In Telnet/Ssh Sessions (Portvision Dx) - Comtrol DeviceMaster EIP Series Hardware Installation And Configuration Manual

Ethernet/ip

Table of Contents

Managing the DeviceMaster

Accessing RedBoot Commands in Telnet/SSH Sessions (PortVision DX)

You can open a Telnet or SSH session using PortVision DX to access RedBoot commands.

Use the following procedure to access a telnet or SSH session with PortVision DX.

1. In PortVision DX, PortVision DX, right-click the DeviceMaster in the Device List pane for which you want

to open a telnet session, and click Telnet/SSH Session.

2. Select Telnet or SSH, leave the Selected Port number, and click Ok.

3. If necessary, enter the

password and press Enter. If a

password has not been set,

press Enter. If using an SSH

session, press Enter to the login

as prompt.

If the PuTTY screen flashes in

the background and does not

appear as shown above, make

sure that Enable Telnet/ssh has

not been disabled in the web

page. To check this, return to

PortVision DX, right-click the

62 - Managing the DeviceMaster

DeviceMaster EIP | UP Hardware Installation and Configuration Guide: 2000633 Rev. C

Table of Contents