Uploading Protocol-Specific Firmware On The Devicemaster - Comtrol DeviceMaster EIP Series Hardware Installation And Configuration Manual

Uploading Protocol-Specific Firmware on the DeviceMaster

Some DeviceMaster models come from the factory with SocketServer firmware, which provides an interface to
TCP/IP socket mode configuration and services, installed on the device.
If your DeviceMaster contains SocketServer and you want to configure one of the following environments, you
must replace SocketServer with protocol-specific firmware.
You can download the latest firmware and corresponding documentation for your protocol from the download
site: 
http://downloads.comtrol.com/html/DM_UP_Main.htm.
If necessary, use the following procedure to update the firmware on your DeviceMaster for the appropriate
protocol. See Locating Software and Documentation
protocol.
Note: If you have not done so, install PortVision DX
firmware.msi file.
1. Execute the .msi file that you downloaded for the firmware.
2. Start PortVision DX by double-clicking the PortVision DX desktop icon or click Comtrol > PortVision DX.
3. Right-click the device or devices for which you want to upload firmware and click the Advanced > Upload
Firmware menu option.
Note: Optionally, you can highlight a device and use the Load button.
4. Browse and select the protocol firmware (.cmtl) file and click Open.
DeviceMaster EIP | UP Hardware Installation and Configuration Guide: 2000633 Rev. C
Preparing the DeviceMaster for Configuration
on Page 8, if you need to download the .msi file for your
(Installing PortVision DX
Preparing the DeviceMaster for Configuration - 29
on Page 22) and install the