Comtrol DeviceMaster EIP Series Hardware Installation And Configuration Manual page 17

3. Use the appropriate method for network attachment of your DeviceMaster 2-port:
• EIP-2102: Connect the 10/100 port to the same Ethernet network segment as the host PC using a
standard network cable.
• EIP-2302: Connect either 10/100 port to the same Ethernet network segment as the host PC using a
standard network cable. You can daisy-chain another DeviceMaster or Ethernet device to the other
Ethernet port.
4. Verify that the Status LED has completed the boot cycle and network connection for the DeviceMaster is
functioning using the following table.
The STATUS LED on the device is lit, indicating you have power and it has completed the
boot cycle.
STATUS
Note: The Status LED flashes while booting and it takes approximately 15 seconds for
If the LINK (green) LED is lit, it indicates a working Ethernet connection.
LINK
If the ACT (yellow) LED flashes, it indicates network activity.
ACT
Note: For additional LED information, go to the
Do not connect RS-422/485 devices until the IP address is configured and an appropriate
port interface type has been configured. The default port setting is RS-232.
5. Go to Preparing the DeviceMaster for Configuration
configure the DeviceMaster for use.
DeviceMaster EIP | UP Hardware Installation and Configuration Guide: 2000633 Rev. C
EIP-2102 and EIP-2302
(2-Port with DB9 Connectors) LED Descriptions
the Bootloader to complete the cycle. When the Bootloader completes the cycle, the
LED has a solid, steady light that blinks approximately every 10 seconds.
Status LED table on Page 80.
on Page 21 for default network settings and how to
Hardware Installation
Hardware Installation - 17