Local Using The Ip Address Or Mac Address - Comtrol DeviceMaster EIP Series Hardware Installation And Configuration Manual

Managing the DeviceMaster
7. Enter the IP Address for the DeviceMaster. It is not necessary to enter the Subnet Mask and Default
Gateway.
8. Click Ok to close the Add New Device window. It may take a few moments to save the DeviceMaster.
9. If necessary, click Refresh for the new DeviceMaster to display in the Device Tree or Device List panes. The
DeviceMaster shows OFF-LINE if it is not attached to the network or if an incorrect IP address was
entered.

Local Using the IP Address or MAC Address

Use the following procedure to add a local DeviceMaster to PortVision DX if you do not want to scan the
network.
1. Locate the network information or MAC address of the DeviceMaster you want to add.
2. Access the New Device window using one of these methods:
• Click Add New > Device in the Manage menu.
• Right-click a folder or a RocketLinx switch in the Device Tree pane (anywhere in the pane, as long as a
DeviceMaster is not highlighted and you are in a valid folder) and click Add New > Device.
3. Select the DeviceMaster in the Device Type drop list.
4. Select the appropriate model in the Device Model drop list.
5. Enter a friendly device name in the Device Name list box.
6. Select LOCAL for the Detection Type.
54 - Managing the DeviceMaster DeviceMaster EIP | UP Hardware Installation and Configuration Guide: 2000633 Rev. C