Product Name Change Notification; 1-Port - Panel Mount (Db9) Installation - Comtrol DeviceMaster EIP Series Hardware Installation And Configuration Manual

Hardware Installation

Product Name Change Notification

Comtrol has implemented a product name change for our DeviceMaster 2-port DIN rail models to align with
our new 1-port and 4-port DIN rail model names.
Old Name/Description
DeviceMaster EIP or DeviceMaster UP 2-Port 1E
EtherNet/IP
DeviceMaster EIP or DeviceMaster UP 2-Port DB9 1E
EtherNet/IP
DeviceMaster EIP or DeviceMaster UP 2-Port 2E
EtherNet/IP
DeviceMaster EIP or DeviceMaster UP 2-Port DB9 2E
EtherNet/IP

1-Port - Panel Mount (DB9) Installation

Use the following procedure to install the DeviceMaster 1-Port (panel mount).
1. Place the DeviceMaster 1-Port on a stable surface and skip to
DeviceMaster using the mounting flanges or DIN rail adapters.
a. Pick up the DeviceMaster so that the front of the device is facing you.
b. Pick up a DIN rail clip. (The three tines should be on top and the M4 label should
face you.)
c. Slide the DIN rail clip behind the DeviceMaster and line it up with one of the screw
holes on the DeviceMaster.
d. Insert the M4 screw into the hole and tighten with a Phillips screwdriver.
e. Repeat Steps b
both DIN rail clips line up.
Note: If you need to remove the DeviceMaster from the DIN rail, exert pressure on
the backside of the tabs at the bottom of both DIN rail clips.
f. Attach the DeviceMaster to the DIN rail.
Note: Do not connect multiple units until you have changed the default IP address, see
DeviceMaster for Configuration
2. Connect the DeviceMaster port labeled 10/100 ETHERNET to the same Ethernet network segment as the
PLC using a standard network cable.
3. Apply power to the DeviceMaster using the following procedure.
Note: See 1-Port Panel Mount 5-30VDC Power Supply
supply.
10 - Hardware Installation
through d with the second DIN rail clip. Make sure the screws on
DeviceMaster
on Page 21
DeviceMaster EIP | UP Hardware Installation and Configuration Guide: 2000633 Rev. C
New Model Name
DeviceMaster EIP-2202
DeviceMaster EIP-2102
DeviceMaster EIP-2402
DeviceMaster EIP-2302
Step 2 or optionally mount the
Front View
on Page 73, if you want to provide your own power
Part Number
99531-9
99551-7
99541-8
99561-6
DIN Rail
Clip
M4
Side
Press here
Preparing the