Changing The Bootloader Timeout - Comtrol DeviceMaster EIP Series Hardware Installation And Configuration Manual

7. Enter the MAC address or network information.
Note: A MAC address label is attached to all DeviceMaster units. The first three pairs of digits start with
00 C0 4E.
8. Optionally, enter the serial number in the Serial Number list box.
9. Click Ok.
10. If necessary, click Refresh for the new DeviceMaster to display in the Device Tree or Device List panes. The
DeviceMaster shows OFF-LINE if it is not attached to the network or if an incorrect IP address was
entered.

Changing the Bootloader Timeout

1. Use the following procedure to change the Bootloader timeout to 45 seconds. You can use this procedure to
return the Bootloader timeout to 15 seconds after you have successfully uploaded the firmwareIf
necessary, use your browser to access the DeviceMaster using the IP address.
2. Click Network.
3. Enter 45 in the Boot Timeout field and click Save.
Note: You should return the Bootloader Timeout value back to 15 seconds after you upload the firmware.
DeviceMaster EIP | UP Hardware Installation and Configuration Guide: 2000633 Rev. C
Managing the DeviceMaster
Managing the DeviceMaster - 55