Establishing A Telnet Connection - Comtrol DeviceMaster EIP Series Hardware Installation And Configuration Manual

Establishing a Telnet Connection

Use the following procedure to telnet to the DeviceMaster.
1. Open a telnet session, enter the DeviceMaster IP address.
If using Windows, you can use PortVision DX, see
(PortVision DX) on Page 62.
2. Press the Enter key if you did not program a password or type the password and press Enter.
Note: The DeviceMaster does not come pre-programmed with a password.
3. Type reset, and close the session.
4. Open a new telnet session, enter the DeviceMaster IP address, and the password.
5. Type dis to disable the Bootloader.
6. Verify that the system responds with a Loading disabled message.
DeviceMaster EIP | UP Hardware Installation and Configuration Guide: 2000633 Rev. C
Accessing RedBoot Commands in Telnet/SSH Sessions
RedBoot Procedures
RedBoot Procedures - 67