Comtrol DeviceMaster EIP Series Hardware Installation And Configuration Manual page 30

Preparing the DeviceMaster for Configuration
5. Click Yes to upload the firmware.
6. Click OK to the advisory message about waiting until the DeviceMaster is on-line and in the next minute
the DeviceMaster unit or units should display ON-LINE in the Status field.
7. Go to the appropriate Quick Start or User Guide for your protocol for information about configuring the
serial port or ports using the web page and programming your PLCs. See
Documentation on Page 8 to locate the document for your protocol.
If you are planning on installing multiple DeviceMasters, you may want to use the Save/Load
Configuration File feature in PortVision DX.
A configuration file can contain network settings and protocol settings. Refer to the PortVision DX help
system for information about saving and loading configuration files.
8. After configuring the serial port characteristics and preparing your PLC programs, you can use the next
section in this guide, to attach the serial device or devices.
30 - Preparing the DeviceMaster for Configuration DeviceMaster EIP | UP Hardware Installation and Configuration Guide: 2000633 Rev. C
Locating Software and