Comtrol DeviceMaster EIP Series Hardware Installation And Configuration Manual page 24

Preparing the DeviceMaster for Configuration
7. Click Install.
8. Depending on the operating system, you may need to click Yes to the Do you want to allow the following
program to install software on this computer? query.
9. Click Launch PortVision DX and Finish in the last installation screen.
10. Depending on the operating system, you may need to click Yes to the Do you want to allow the following
program to make changes to this computer? query.
11. Select the Comtrol Ethernet-attached products
that you want to locate and then click Scan.
Note: If the Comtrol Ethernet-attached product
is not on the local segment and it has been
programmed with an IP address, it will be
necessary to manually add the Comtrol
Ethernet-attached product to PortVision
DX.
12. Go to Step 5 in the next section, Configuring the
Network Settings, to program the DeviceMaster
network settings.
If you need additional information about PortVision
DX, refer to the Help system.
24 - Preparing the DeviceMaster for Configuration
You can save time if you only scan for DeviceMasters.
DeviceMaster EIP | UP Hardware Installation and Configuration Guide: 2000633 Rev. C