Comtrol DeviceMaster EIP Series Hardware Installation And Configuration Manual page 15

4. Verify that the Status LED has completed the boot cycle and network connection for the DeviceMaster is
functioning properly using the following table.
(2-Port with Serial Terminal Connectors) LED Descriptions
The STATUS LED is lit, indicating you have power and it has completed the boot cycle.
Note: The Status LED flashes while booting and it takes approximately 15 seconds for
STATUS
If the LINK (green) LED is lit, it indicates a working Ethernet connection.
LINK
ACT If the ACT (yellow) LED flashes, it indicates network activity.
Note: For additional LED information, go to the
Do not connect RS-422/485 devices until the IP address is configured and an
appropriate port interface type has been configured. The default port setting is RS-232.
5. Go to Preparing the DeviceMaster for Configuration
configure the DeviceMaster for use.
DeviceMaster EIP | UP Hardware Installation and Configuration Guide: 2000633 Rev. C
EIP-2202 and EIP-2402
the Bootloader to complete the cycle. When the Bootloader completes the cycle,
the LED has a solid, steady light that blinks approximately every 10 seconds.
Status LED table on Page 80.
on Page 21 for default network settings and how to
Hardware Installation
Hardware Installation - 15