Table of Contents
Advertisement
Connecting Serial Devices
This section discusses connecting your serial devices to the DeviceMaster. It also provides you with
information to build serial cables and loopback connectors to test the serial ports.
•
DB9 Connectors
•
RJ45 Connectors
on Page 39
•
Four Screw Terminals (EIP-2202)
•
Eight Screw Terminals (EIP-2402)
•
Nine Screw Terminals (EIP-2201)
Make sure that you have configured the ports for the correct communications mode before
connecting any devices. The default mode is RS-232. There is a remote possibility that
Caution
connecting a serial device for the wrong mode could damage the serial device.
DeviceMaster EIP | UP Hardware Installation and Configuration Guide: 2000633 Rev. C
on Page 42
on Page 45
on Page 48
Connecting Serial Devices - 35
Advertisement
Table of Contents
Troubleshooting
