Table of Contents
Advertisement
Centerplane replacement
Complete the following steps to remove the centerplane.
Note:
1. Turn off the server (see "Turning off the server" on page 11) and disconnect all
2. Remove the PCI brick from the server (see "PCI brick" on page 125) and place
3. Remove the centerplane by turning the two centerplane thumbscrews ( 1 ) to
4. To replace the centerplane, reverse the previous steps.
128
xSeries 440 Type 8687: Hardware Maintenance Manual
v Read "Installation guidelines" on page 71.
v Read the safety notices at "Safety notices (multi-lingual translations)" on
page 205.
v Read "Handling electrostatic discharge-sensitive devices" on page 204.
power cords and external cables.
it on a clean work surface.
Note: The illustrations in this document might differ slightly from the hardware
being serviced.
release it; then, carefully lift the centerplane out of its socket ( 2 ).
Advertisement
Table of Contents
