Table of Contents
Advertisement
3. Connect the SMP Expansion cables to the secondary server.
4. Route any remaining cables through the cable-management arms.
5. Secure the cables in the cable-management arms with the hook-and-loop straps
6. If you are connecting to an IBM RXE-100 Remote Expansion Enclosure, go to
7. Turn on the primary server; then, see the software documentation that comes
Deleting a static partition: Complete the following steps to delete the static
partition:
1. Start the Configuration/Setup Utility on the primary server.
2. Select Advanced Setup from the main menu.
3. Select Static Partition Settings.
4. Select Delete Static Partition Settings.
5. Exit the Configuration/Setup Utility Program.
6. Turn the servers off and disconnect all interconnecting cables between the two
Using the SCSISelect utility program
SCSISelect is a built-in, menu-driven configuration utility program that you can use
to:
v View the default SCSI IDs
v Locate and correct configuration conflicts
a. Locate the SMP Expansion cable that is connected to port 1 of SMP
Expansion Module 0 on the primary server; then, connect the opposite end
of the cable to port 1 of SMP Expansion Module 2. Next, route the cable
through the secondary cable-management arm.
b. Locate the SMP Expansion cable that is connected to port 2 of SMP
Expansion Module 1 on the primary server; then, connect the opposite end
of the cable to port 2 of SMP Expansion Module 2. Next, route the cable
through the secondary cable-management arm.
c. Locate the SMP Expansion cable that is connected to port 1 of SMP
Expansion Module 1 on the primary server; then, connect the opposite end
of the cable to port 1 of SMP Expansion Module 3. Next, route the cable
through the secondary cable-management arm.
d. Locate the SMP Expansion cable that is connected to port 2 of SMP
Expansion Module 0 on the primary server; then, connect the opposite end
of the cable to port 2 of SMP Expansion Module 3. Next, route the cable
through the secondary cable-management arm.
e. Verify that a short SMP Expansion cable is connected between port 3 of
SMP Expansion Module 2 and port 3 of SMP Expansion Module 3.
that come with your server.
"Cabling an RXE-100 Remote Expansion Enclosure to a 16-way system" on
page 119 for instructions on how to connect the IBM RXE-100 to a 16-way
system; then, return here.
with your server to install your operating system.
Important: Do not use ServerGuide to install the operating system that comes
with your server.
Note: Do not select Save Static Partition Settings when you delete the static
partition.
servers.
25
Configuration
Advertisement
Table of Contents
