Removing An Smp Expansion Module And Cover - IBM eserver xSeries 440 8687 Hardware Maintenance Manual

Removing an SMP Expansion Module and cover

While installing options, you might need to remove one or both of the SMP
Expansion Modules. This section provides instructions on removing an SMP
Expansion Module from the server and removing the cover from the module.
Note: When you install or remove SMP Expansion Modules, the server
Complete the following steps to remove an SMP Expansion Module from the server:
1. Review the information in "Installation guidelines" on page 71, "Handling
2. Turn off the server and peripheral devices, disconnect the power cords and all
3. If necessary, remove the SMP baffle and retention bracket from the server.
4. To remove the EMC shield from the rear of the server:
configuration information changes. Therefore, you must change and save the
new configuration information by using the Configuration/Setup Utility
program (see "Starting the Configuration/Setup Utility program" on page 16).
electrostatic discharge-sensitive devices" on page 204, and "Safety information"
on page 201.
external cables from the SMP Expansion Module; then, open the cover (see
"Opening the cover" on page 72 for details).
a. Remove the shipping thumbscrews from the right side of the server.
Retention bracket
removal handles
b. Open the cover.
c. Grasp the retention bracket by the removal handles and lift it up and out of
the server.
Note: If there is one SMP Module installed, you will need to remove the
SMP baffle from the server; then, remove the retention bracket from
the lower SMP Module as described in steps 3a through 3c.
Retention bracket
SMP Expansion
Module
Shipping thumbscrews
Installing options
87