Reinstalling an SMP Expansion Module and cover
After installing options in the SMP Expansion Module, you will need to reinstall the
SMP Expansion Module cover and reinstall the SMP Expansion Module in the
server.
Note: When you install or remove SMP Expansion Modules, the server
Complete the following steps to reinstall the SMP Expansion Module cover:
1. Install the cover on the SMP Expansion Module:
configuration information changes. Therefore, you must change and save the
new configuration information by using the Configuration/Setup Utility
program (see "Starting the Configuration/Setup Utility program" on page 16).
a. Set the cover on top of the expansion module.
Locking levers
CAM opening
b. Extend the locking levers as shown in the illustration; then, let the cam on
the front of the cover fall into the cam opening on the SMP Expansion
Module circuit board.
c. Release the locking levers and align the rear of the cover with the rear edge
of the circuit board.
d. Press down on the cover until it snaps into place.
e. Lift slightly on the locking levers and rotate them back until they stop.
101
Installing options