SMP Expansion Module
The SMP Expansion Module contains the XceL4
microprocessors, and voltage regulator modules (VRMs) needed to run the server.
This section contains the information needed to install and remove the SMP
Expansion Module, microprocessors, VRMs, and DIMMs.
SMP Expansion Module considerations:
v Use two hands to install or remove an SMP Expansion Module. Do not allow the
v For the server to operate properly, there must be a minimum of one SMP
v An SMP Expansion Module must contain at least one microprocessor and four
v If it becomes necessary to remove or install DIMMs do so through the DIMM
v Before removing or installing SMP Expansion Modules you must remove the
v You must run the Configuration/Setup Utility whenever you remove or replace a
86
xSeries 440 Type 8687: Hardware Maintenance Manual
expansion module to come in contact with any of the boards, especially the
centerplane, while lifting it out or putting it into the server.
Expansion Module and one SMP baffle installed.
DIMMs.
access doors on the SMP Expansion Module. Refer to "DIMM removal and
replacement" on page 93 for the location of the DIMM access doors.
electromagnetic compatibility (EMC) shield and SMP Expansion cables from the
rear of the server.
SMP Expansion Module or one of its associated options.
Note: The illustrations in this document might differ slightly from your hardware.
Locking levers
CAM opening
™
system cache, DIMMs,