Table of Contents
Advertisement
v If the server is turned on and a power failure occurs, the server will restart
v If ac power is present and the server is in Standby mode, the server can be
v When you plug in the server for the first time, Wake on LAN can turn on the
v If the server was previously turned on, it must be properly placed in Standby
Complete the following steps to manually turn on the server:
1. Review the information in "Safety information" on page 201.
2. Turn on all external devices, such as the monitor.
3. Plug the server power cords into the power source.
4. Press the power-control button on the front of the server.
Turning off the server
Note: Pressing the power-control button on either the primary or secondary server
Complete the following steps to manually turn off the server:
1. Review the information in "Safety information" on page 201.
2. See your operating system documentation for the proper procedure to shut
3. Press the power-control button on the front of the server. This will put the server
this time, the system-management adapter is initializing; therefore, the
power-control button does not respond.
automatically when power is restored.
turned on from the Remote Supervisor Adapter user interface.
server.
mode for the Wake on LAN feature to turn on the server.
Note: While the server is powering up, the power-on LED on the front of the
server is lit.
in the 16-way configuration (models 1VX, 2VX, 3VX only) will turn on or turn
off both servers.
down the operating system.
Statement 5
CAUTION:
The power control button on the device and the power switch on the power supply do
not turn off the electrical current supplied to the device. The device also might have
more than one power cord. To remove all electrical current from the device, ensure
that all power cords are disconnected from the power source.
in Standby mode.
Note: You might need to press and hold the power-control button for more than
4 seconds to cause an immediate shutdown of the server and to force it
into Standby mode. You can use this feature if the operating system
stops functioning.
11
General information
Advertisement
Table of Contents
