IBM eserver xSeries 440 8687 Hardware Maintenance Manual page 146

134
xSeries 440 Type 8687: Hardware Maintenance Manual
a. Remove any adapters and adapter separators that are installed (see "PCI
and PCI-X adapters" on page 77), unplugging any necessary cables.
Note: The illustrations in this document might differ slightly from the
hardware being serviced.
Notches
Tabs
b. Release the PCI-X assembly from the I/O board at the four notches that
secure them together, then lift the PCI-X assembly off of the I/O board and
set it in a safe place.
Note: The illustrations in this document might differ slightly from the
hardware being serviced.
System
Management
Board
PCI-X
Board
I/O Board
PCI-X Assembly
I/O Board
Riser
Card
Screws from
Serial Port
SCSI Cable