Top power board
Complete the following steps to remove the top power board.
Note:
1. Turn off the server (see "Turning off the server" on page 11) and disconnect all
2. Remove the top cover assembly (see "Top cover assembly" on page 138) and
3. Remove the two screws securing the power board to the top cover.
4. Pull the power board away from the cover.
5. To install the top power board, reverse the above steps.
v Read "Installation guidelines" on page 71.
v Read the safety notices at "Safety notices (multi-lingual translations)" on
page 205.
v Read "Handling electrostatic discharge-sensitive devices" on page 204.
power cords and external cables.
set it upside-down on a clean work surface.
Note: The illustrations in this document might differ slightly from the hardware
being serviced.
FRU information (service only)
139