Power/reset card assembly
The power/reset card assembly is located on the left front of the server. Complete
the following steps to remove the power/reset card assembly.
Note:
1. Turn off the server (see "Turning off the server" on page 11) and disconnect all
2. Remove the front bezel (see "Bezel removal" on page 74).
3.
4. Disconnect the power/reset card cable from the I/O board.
5. Remove the screw that attaches the card to the chassis and carefully set it
6. Remove the card assembly from the server by drawing the cable through the
7. To replace the card assembly, reverse the previous steps, threading the cable
v Read "Installation guidelines" on page 71.
v Read the safety notices at "Safety notices (multi-lingual translations)" on
page 205.
v Read "Handling electrostatic discharge-sensitive devices" on page 204.
power cords and external cables.
Remove fans 3 and 4 in order to access the power/reset cable.
aside.
channel in the side of the chassis and out the front.
through the gap in the chassis.
FRU information (service only)
147