Table of Contents
Advertisement
The following illustration shows the pin-number assignments for the keyboard
connector on the end of the cable.
Remote Supervisor Adapter communication ports
The server has four communication ports that are used by the Remote Supervisor
Adapter. Three of the ports are located on the adapter and one is located at the
lower left corner of the rear panel (as viewed from the rear).
If you want to use the Remote Supervisor Adapter to manage the server remotely
or to connect the server to another server, connect the appropriate cables to the
Remote Supervisor Adapter ports.
To enable remote server management through a network, use the Remote
Supervisor Adapter Ethernet port (RJ-45). To enable remote server management
using a modem, use the Remote Supervisor Adapter serial port. To connect the
server with another server, use the ASM interconnect port (RJ-14). See the Remote
Supervisor Adapter documentation on the IBM Documentation CD for more
information.
The following illustration shows the communication ports on the Remote Supervisor
Adapter.
External power
connector
External power connector
startup. For detailed information about this option and how to connect it to
the server, refer to the documentation that comes with the option.
Table 7. Keyboard connector pin-number assignments
Pin
I/O
1
I/O
2
N/A
3
N/A
4
N/A
5
I/O
6
N/A
Error LED
(amber)
Power LED
(green)
This connector provides power to the Remote Supervisor Adapter,
independent of the server power supply.
6
5
3
4
1
2
Signal
Data
Reserved
Ground
+5 V dc
Keyboard clock
Reserved
Ethernet activity LED
(green)
ASM interconnect
port
Management port
Ethernet link LED
(green)
10/100
Ethernet port
Installing options
111
Advertisement
Table of Contents
