I/O board
This section illustrates the internal connectors on the I/O board, and provides
instructions for I/O board replacement.
I/O board internal connectors
The following illustration identifies the internal connectors on the I/O board. This
board supports the input and output ports located on the server.
SCSI B
connector (J38)
I/O VRM (J31)
Fan 4
connector (J21)
Fan 3
connector (J9)
Power/Reset
connector (J5)
Note: The default position for J4, J10, J20 and J28 is pins 1 and 2.
Power switch bypass
The power switch can by bypassed (force power on) using the J5 connector on the
I/O board.
Pin 1
Reset button
(0=pressed)
Unplug the J5 connector; then, either connect another power switch or connect pin
6 to pin 4 to simulate a button press.
132
xSeries 440 Type 8687: Hardware Maintenance Manual
SCSI A
Media bays
connector (J2)
connector (J3)
Pin 2
Pin 3
Ground
3.3V standby
Pin 4
Pin 5
Pin 6
Power button
Power LED
Power/reset switch present
(0=pressed)
(0=LED on)
(0=present)
Riser card
connector (J44)
Boot recovery
(BIOS) (J28)
Reserved (J4)
3
3
2
2
1
1
3
3
2
2
1
1
Reserved (J19)
Power-on
password (J20)
3
3
2
2
1
1
3
3
2
2
1
1
Fans 1 and 2
connectors (J8)
USB cable
connector (J1)