Table of Contents
Advertisement
Table 14. SCSI identifier (continued)
SCSI Channel Code (z)
D
E
F
b. Confirm that the channel(s) identified from the error in step 2a on page 188
is (are) the cause of the error by verifying that the error presents itself only
when the offending channel is reconnected.
c. Check termination of identified channel.
Note: SCSI channel termination details, if any, appear elsewhere in this
publication.
d. Check for proper backplane jumper configuration.
Note: SCSI channel jumper details, if any, appear elsewhere in this
publication.
e. Check for proper cabling configuration in systems that use hard disk drive
status cables. Reconnect all cables removed in step 1 on page 188.
f. Disconnect one drive at a time attached to the channel identified in step 2a
on page 188; then, reboot to determine which drive is causing the error.
g. Replace hard disk drive cable.
h. Replace hard disk drive backplane.
FFFF or other code not listed
1. Place download jumpers on the controller and try to flash the firmware code to
the card.
2. Isolate between SCSI subsystem and controller by disconnecting all hard disk
drive cables attached to the suspect card, and reboot.
CAUTION:
Do not press F5. Doing so will change the server's configuration.
If ISPR code is EF10 after disconnecting cables, follow the steps below until the
error is eliminated:
a.
Identify which channel is causing the error by reconnecting cables one at a
time and rebooting until the error returns.
b. Check termination of identified channel in step 2a.
Note: SCSI channel termination details, if any, appear elsewhere in this
publication.
c. Disconnect one drive at a time attached to channel identified in step 2a and
reboot each time to determine which drive is causing the problem.
d. Replace hard disk drive cable attached to channel identified in step 2a.
e. Replace backplane attached to channel identified in step 2a.
3. If original ISPR code is still present after disconnecting all hard disk drive cables
and rebooting, perform the following actions until the error is no longer present:
v Reseat the controller
v Replace the controller
Descriptions
Channel 1, 3, & 4
Channel 2, 3, & 4
Channel 1, 2, 3, & 4
Symptom-to-FRU index
189
Advertisement
Table of Contents
