Retention bracket removal
The server comes with one retention bracket. This bracket is used to secure the
SMP Modules in place. It will be easier to remove the SMP Modules if the retention
bracket is removed.
Complete the following steps to remove the retention bracket from the server.
1. Remove the shipping screws from the right side of the server.
2. Open the cover.
3. Grasp the bracket by the two blue tabs and lift it up and out of the server.
Retention bracket
removal handles
Note: It is recommended that the retention bracket remain in place during
normal operation of the server.
Retention bracket
SMP Expansion
Module
Shipping thumbscrews
Installing options
73